"HARDWIRED 24VAC ADAPTER KIT FOR ENMOTION® FLEX AUTOMATED PAPER TOWEL DISPENSERS 59762, 59766 & 59798 BY GP PRO, 1 KIT""$42.00" "https://d3f8e2yx8gxglk.cloudfront.net/adaptivemedia/rendition?id=33b72308153cca68be456c0d349fdcdaa90dc76e&vid=33b72308153cca68be456c0d349fdcdaa90dc76e&prid=65Wx65H&clid=SAPDAM" "inStock" "USD" "AC Transformer (Not Included): A 24V transformer should be used. One dispenser will run off approximately 10 Volt-Amps of power, so one transformer may be used for more than one dispenser. Consult a licensed electrical contractor for the installation of the transformer into the junction box. Georgia-Pacific Corporation recommends using a UL listed, 24 Volt transformer with at least 10 Volt-Amps of power per dispenser. The power supply output cord is intended to route through the mounting wall of the dispenser. This is a low voltage, energy limited circuit, similar to those used for thermostats, telephones, security systems, or doorbells. In these applications, there is no requirement for an electrical box or strain relief where the wire exits the wall."
"$42.00" "HARDWIRED 24VAC ADAPTER KIT FOR ENMOTION® FLEX AUTOMATED PAPER TOWEL DISPENSERS 59762, 59766 & 59798 BY GP PRO, 1 KIT" "https://d3f8e2yx8gxglk.cloudfront.net/adaptivemedia/rendition?id=33b72308153cca68be456c0d349fdcdaa90dc76e&vid=33b72308153cca68be456c0d349fdcdaa90dc76e&prid=65Wx65H&clid=SAPDAM" "AC Transformer (Not Included): A 24V transformer should be used. One dispenser will run off approximately 10 Volt-Amps of power, so one transformer may be used for more than one dispenser. Consult a licensed electrical contractor for the installation of the transformer into the junction box. Georgia-Pacific Corporation recommends using a UL listed, 24 Volt transformer with at least 10 Volt-Amps of power per dispenser. The power supply output cord is intended to route through the mounting wall of the dispenser. This is a low voltage, energy limited circuit, similar to those used for thermostats, telephones, security systems, or doorbells. In these applications, there is no requirement for an electrical box or strain relief where the wire exits the wall."