Georgia-Pacific | Professional




Live Chat


enMotion® Recessed Automated Towel Dispenser

INSTALLATION OF DISPENSER INTO SHEETROCK WALL

  1. Locate stud in wall and cut hole to accommodate enMotion Recessed Automated Touchless Towel Dispenser.
  2. Cut hole that is 10-5/8" wide by 15-3/16" length.
    Cut hole with sheetrock saw
  3. Install and fit enMotion Recessed Automated Touchless Towel Dispenser into wall cavity.
  4. Ensure enMotion Recessed Automated Touchless Towel Dispenser is attached to stud or frame cavity as necessary.
    Note: enMotion Recessed Automated Touchless Towel Dispenser will need to be grounded to operate properly.
  5. Locate mounting slots inside enMotion Recessed Automated Touchless Towel Dispenser.
  6. Secure through mounting slots into studs.
    Secure dispenser through mounting slots into studs.
  7. Install battery pack and test.
  8. Load Georgia-Pacific roll towel and close door.
    Load roll towel and close door.
  9. Clean off enMotion Recessed Automated Touchless Towel Dispenser using isopropyl rubbing alcohol.
    Clean off dispenser using isopropyl rubbing alcohol.

enMotion® dispensers are offered via a lease agreement through an authorized distributor.