Georgia-Pacific | Professional

• Step 1 - Removing Door from Existing Cabinet
• Step 2 - Removing Towel Dispenser from Cabinet
• Step 3 - Installation of the New enMotion Recessed Automated Touchless Towel Dispenser

STEP 1 - REMOVING DOOR FROM EXISTING CABINET

1. Apply masking tape above and below the hinge to protect the cabinet while removing the door.
   
2. With door closed and locked (some ASI units require the door to be open), drive the hinge pin down from the top using a drift pin and hammer.
   
3. Grip the bottom of the hinge pin with vise grip pliers and pull down to remove. If the pin does not slide out easily, tap the vise grips lightly with a hammer.
   
4. Open and remove the door. Remove the protective tape.

STEP 2 - REMOVING TOWEL DISPENSER FROM CABINET

1. Using a Phillips head screwdriver, remove the four screws that secure the towel dispenser inside the cabinet.
   Note: In some cases this unit may be spot welded in the cabinet. You will be required to break the weld using a small hammer and chisel.
   
2. Once the Roll Towel dispenser has been removed you are now ready to install the enMotion Recessed Automated Touchless Towel Dispenser.

Note: This installation will require a custom Filler Panel. Contact a GP Marketing Services representative for Filler Panel availability options. Call 1-877-377-2737 or e-mail us.
Please allow at least 14 working days for delivery.

STEP 3 - INSTALLATION OF THE NEW ENMOTION RECESSED AUTOMATED TOUCHLESS TOWEL DISPENSER

1. Since this cabinet is very deep and wide, it will be necessary to install wood shims on each side and in the back of the cabinet in order to secure the new enMotion Recessed Automated Touchless Towel Dispenser.
   
2. Remove the plastic protective film from the Custom Filler Panel. Apply two-way tape to the inside flanges Filler Panel.
3. Insert enMotion Recessed Automated Touchless Towel Dispenser into the Filler Panel. The two-way tape will help hold the Filler Panel around the unit during installation.
   Note: Be sure that the grounding plate located on the flange of the enMotion Recessed Automated Touchless Towel Dispenser is touching the Filler Panel. This will allow for the dispenser to be properly grounded.
   
4. Open the door of the enMotion Automated Touchless Towel Dispenser. You will see holes in the chasse that will allow you to secure the unit into the wood shims using #10 screws. Insert the dispenser and Filler Panel into the cavity inside the cabinet. The Filler Panel should flush with the face of the cabinet. While holding the enMotion Recessed Automated Touchless Towel Dispenser firmly in position, insert two #10 screws in each side of the dispenser.
   
5. Install battery pack and test.
6. Load Georgia-Pacific roll towel and close door.
   
7. Clean off unit using isopropyl rubbing alcohol.